Darcy–Brinkman–Forchheimer Model for Film Boiling in Porous Media

The paper presents results of the modelling of heat transfer at film boiling of a liquid in a porous medium on a vertical heated wall bordering with the porous medium. Such processes are observed at cooling of high-temperature surfaces of heat pipes, microstructural radiators etc. Heating conditions at the wall were the constant wall temperature or heat flux. The outer boundary of the vapor film was in contact with moving or stationary liquid inside the porous medium. An analytical solution was obtained for the problem of fluid flow and heat transfer using the porous medium model in the Darcy–Brinkman and Darcy–Brinkman–Forchheimer approximation. It was shown that heat transfer at film boiling in a porous medium was less intensive than in the absence of a porous medium (free fluid flow) and further decreased with the decreasing permeability of the porous medium. Significant differences were observed in frames of both models: 20% for small Darcy numbers at Da < 2 for the Darcy–Brinkman model, and 80% for the Darcy–Brinkman–Forchheimer model. In the Darcy–Brinkman model, depending on the interaction conditions at the vapor–liquid interface (no mechanical interaction or stationary fluid), a sharp decrease in heat transfer was observed for the Darcy numbers lower than five. The analytical predictions of heat transfer coefficients qualitatively agreed with the data of Cheng and Verma (Int J Heat Mass Transf 24:1151–1160, 1981) though demonstrated lower values of heat transfer coefficients for the conditions of the constant wall temperature and constant wall heat flux.